• October 23, 2020, 03:41:05 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: ONVIF support?  (Read 439 times)

aagaag

  • Level 1 Member
  • *
  • Posts: 3
ONVIF support?
« on: August 06, 2020, 01:17:50 PM »

This cam is supposed to have ONVIF support. I tried to get it to work with Netcam Studio, but I couldn't get it to work. Specifically, the software could not retrieve any ONVIF profiles from the camera. Did anybody get it to work with ANY kind of ONVIF software? Also, even with the MyDlink android app, I was unable to get motion-activated recording to work.
Logged

SmartCookie

  • Level 1 Member
  • *
  • Posts: 9
Re: ONVIF support?
« Reply #1 on: August 07, 2020, 05:34:24 AM »

I can't help with ONVIF as I've never used it. In terms of recording on motion I found it in the app under the automation section, so you have to set up an automation rule that when there is motion, record. The app isn't very user friendly so it takes time to get used to it.
Logged

aagaag

  • Level 1 Member
  • *
  • Posts: 3
Re: ONVIF support?
« Reply #2 on: August 08, 2020, 03:07:07 AM »

thank you very much. Thanks to your instructions, I finally managed to activate the motion trigger!
Logged

Doctor Doom

  • Level 3 Member
  • ***
  • Posts: 129
Re: ONVIF support?
« Reply #3 on: September 24, 2020, 04:04:39 PM »

If you would like to use VMS or NVR software or D-Viewcam, the username is admin and password is the pincode that's on the device.
Logged