• November 18, 2019, 06:49:55 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DGS-1100-16 HW Rev B2 - SNMP configuration  (Read 366 times)

lanman1052

  • Level 1 Member
  • *
  • Posts: 1
DGS-1100-16 HW Rev B2 - SNMP configuration
« on: July 28, 2019, 08:16:43 AM »


Hello D-Link Forum users,

I have a DGS-1100-16 hardware rev B2. I'm trying to enable SNMP so I can read various metrics from the switch in terms of throughput, collisions, uptime etc.

I've reached out to D-Link support and they've recommended I flash firmware 1.01.B053 onto the device. I did that but SNMP still doesn't work. I'm trying to poll the switch from Cacti to generate graphs from the different interfaces but it keeps timing out.

I've also tried using just regular old snmpwalk but the switch just refuses to answer.

I've simply changed the SNMP global state to enabled, and changed my SNMP read community string.

Does anyone know the secret to enable SNMP on these series of smaller smart switches?

Thank you!
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47912
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DGS-1100-16 HW Rev B2 - SNMP configuration
« Reply #1 on: August 02, 2019, 06:12:55 AM »

Check the user manual for information regarding SNMP.

Contact D-Link support as well...
Logged
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting