• April 22, 2019, 03:19:59 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: "Failed to synchronize the time with NTP server" with 10 sec wifi disconnect  (Read 949 times)

wylajb

  • Level 1 Member
  • *
  • Posts: 18

Hello,

I've got a DCS-2630L Revision A with the 1.05.02 firmware and connected via 5 Ghz wifi.

Overall, the wifi connection is very good, but it seems that at least twice a day, the camera disconnects for ca. 10 seconds at a time.

When I look into the camera's log, I see that each time there is a 10 second disconnect, there is also a "Failed to synchronize the time with NTP server" message in the log.

Further down on the board, it was suggested that one would need to specify DNS servers, in order to get the NTP time sync working, so I added in entries for IPv4 Primary and Secondary Servers (OpenDNS Servers).

This did not change the behavior.

In the camera's "Time and Date" settings, I've tried the following ntp servers with both name and ip address:

   ntp1.dlink.com
   ntp.dlink.com.tw
   time.nist.gov

Wondering if anyone else has reproduced this 10 second disconnect/reconnect behavior with the "Synchronize with NTP Server" "Time and Date" setting?

wylajb
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47220
  • D-Link Global Forum Moderator
    • New DIR-890L Router with SmartConnect™ Technology

Link>Welcome!

  • What region are you located?

What Mfr and model is the ISP modem and main host router?
Logged
"Nothing Funny about It...." We are not here to Impress anyone! You have a be a COMPETENT user first to under stand COMPETENT help!

wylajb

  • Level 1 Member
  • *
  • Posts: 18

Hello Furrynutz,

Thanks for your reply.

I'm located in the D.C. area, and I've got Xfinity internet service with a Motorola Surfboard SB6121 cable modem.  My router is a Netgear R7800 with the latest V1.0.2.62 firmware.

Today, I'm experimenting with different NTP servers to see if it could make a difference.  My current server setting, "0.us.pool.ntp.org" has been running for a couple hours, and I haven't yet seen the "Failed to synchronize the time with NTP server" log entry with the corresponding camera disconnect....time will tell.

wylajb
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47220
  • D-Link Global Forum Moderator
    • New DIR-890L Router with SmartConnect™ Technology

Ok, thanks for letting us know.

if you don't see the log enteries again, please re-configure for time.nist.gov again and test. This should work as well as the others.
Logged
"Nothing Funny about It...." We are not here to Impress anyone! You have a be a COMPETENT user first to under stand COMPETENT help!