• April 20, 2019, 07:20:04 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: 942L camera and NTP service problem  (Read 1001 times)

christianwis

  • Level 1 Member
  • *
  • Posts: 1
942L camera and NTP service problem
« on: September 30, 2018, 07:22:30 AM »

Hello everyone,

I have problems configuring the NTP service. It does not take the changes and always remains with date 2015.01.01

I have firmware 1.27 installed and I have already tried all the options. From NTP de America to Europe and do not take the changes.

I currently put "0.europe.pool.ntp.org" then save changes and then restart. However, it continues with the same date and time "2015.01.01"

Any suggestions?

Thank you very much,
Christian

« Last Edit: September 30, 2018, 07:34:10 AM by christianwis »
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47208
  • D-Link Global Forum Moderator
    • New DIR-890L Router with SmartConnect™ Technology
Re: 942L camera and NTP service problem
« Reply #1 on: September 30, 2018, 11:24:18 AM »

Link>Welcome!

  • What Hardware version is your DCS? Look at the sticker behind or under the camera.
  • Link>What Firmware version is currently loaded? Found on the DCSs web page under status.
  • What region are you located?

What Mfr and model is the main host router?

I currently use ntp1.dlink.com. Try this setting.
Daylight savings enabled and Time Zone is Mouttain for my area.

Might factory reset the camera and set it up from scratch if adjusting the settings doesn't work...
Logged
"Nothing Funny about It...." We are not here to Impress anyone! You have a be a COMPETENT user first to under stand COMPETENT help!