• August 19, 2019, 03:51:41 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Cannot set to DHCP client  (Read 863 times)

Mikemorrell2

  • Level 1 Member
  • *
  • Posts: 3
Cannot set to DHCP client
« on: August 26, 2018, 10:24:45 AM »

Before I switched routers, I had my old router set to reserve a pan iPad based on MAC address.  I got a new ISP and the IP address range is no longer within that same range and Id like to change the 323 not to be static and just be a dhcp client.  But in the settings, every time I try to save this, it keeps going back to the fixed IP address.  It wont allow me to change to dhcp.  Why?
Logged

FurryNutz

  • Poweruser

  • ▲▲
  • *****
  • Posts: 47689
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Cannot set to DHCP client
« Reply #1 on: August 26, 2018, 10:39:57 AM »

Try a factory reset on the DNS and set up from scratch? Or Set the IP address pool on the new router to match what was used before on the old router?
Logged
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting

ivan

  • Level 8 Member
  • ***
  • Posts: 1441
Re: Cannot set to DHCP client
« Reply #2 on: November 26, 2018, 05:07:33 PM »

Also check that your new router isn't using IPv6 addresses that the NAS knows nothing about.  If that is the case you will need to set the router to internal IPv4 addresses (some routers you can set to do so others you can't).
Logged