• January 25, 2020, 05:43:06 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Could D-Link add IPv6 Passthrough mode to DIR-836L?  (Read 3783 times)

LynnField1366

  • Level 1 Member
  • *
  • Posts: 2
Could D-Link add IPv6 Passthrough mode to DIR-836L?
« on: March 14, 2017, 09:58:40 PM »

Could D-Link add IPv6 Passthrough mode to DIR-836L's firmware?
I've tried several routers and found that only in Passthrough mode I can get ipv6 address and visit ipv6 websites.

Or anyone has any other way to help with my case?
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 48236
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Could D-Link add IPv6 Passthrough mode to DIR-836L?
« Reply #1 on: March 15, 2017, 11:39:44 AM »

Link>Welcome!

  • What Hardware version is your router? Look at sticker under the router case.
  • Link>What Firmware version is currently loaded? Found on the routers web page under status.
  • What region are you located?

How do you have the router configured? There is a a drop down for Automatic and Local Only. I think if you use local only with out any other configurations, IPv6 should pass thru. Not sure however.

FYI:
    This product has been discontinued.
    Free support for this product will end on 11/01/2017

You can use this as as LAN to LAN AP then anything will pass-thru: Turning a router into an AP.
Logged
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting