• December 09, 2019, 05:57:21 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: setup http server on D-LINK 2750U  (Read 885 times)


  • Level 1 Member
  • *
  • Posts: 3
setup http server on D-LINK 2750U
« on: January 12, 2017, 02:05:16 AM »


 my firmware si IN_1.08N
Pl tell me steps to expose http server on a.b.c.d:80 onto static ip e.f.g.h which is the ip given by my isa.
The previous answers were vague.



  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47968
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: setup http server on D-LINK 2750U
« Reply #1 on: January 25, 2017, 06:43:07 AM »

I would try using Virtual Server or Port Forwarding to see if you can get this configured.

This modem may not have loopback support as well. I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this. We find that phone contact has better immediate results over using email.

Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting