• October 19, 2019, 02:58:17 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Power Interruption - Set Up Required All Over?  (Read 1051 times)

zippinbye

  • Level 1 Member
  • *
  • Posts: 1
Power Interruption - Set Up Required All Over?
« on: December 01, 2015, 07:28:51 PM »

Brand new user here.  Thanks in advance for any assistance.  I just set my 2330L using a network cable to my Apple AirPort Extreme.  All functions seem good.  Except that my intended mounting location is way too far away from the router to run Cat 5. So unplugged and relocated. Now I can't reconnect to the camera. I've tried twice via a new set up process.  I can't imagine these cameras would not tolerate a power outage.  Surely they don't have to be reconfigured each time power goes away for a short period?  What am I doing wrong? 
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47844
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Power Interruption - Set Up Required All Over?
« Reply #1 on: December 03, 2015, 07:04:36 AM »

Link>Welcome!

  • What Hardware version is your DCS? Look at the sticker behind or under the camera.
  • Link>What Firmware version is currently loaded? Found on the DCSs web page under status.
  • What region are you located?

I recommend setting a static IP address ON the cameras outside of the main host routers default DHCP IP address pool: 192.168.#.23  DHCP

Test cameras with uPnP and uPnP Port Forwarding both enabled on ALL cameras: DCS Cloud (L) Series Camera Configuration and Mydlink.com

If you initially set up the camera for a wired connection and didn't setup for a wireless connection, then you unplugged it and moved location, you'll need to set up the wireless connection first and ensure the mode is working before moving the camera. Just set up the camera again using the LAN cable and configure the camera for the wireless connection to the main host router. Once that's done, reboot the camera and disconnect the LAN cable. The camera should come to ready and be accessible via it's wifi connection. If all is good, power off then move the camera to it's final location.
Logged
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting