• October 29, 2020, 04:43:24 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: dcs-930l  (Read 1620 times)


  • Level 1 Member
  • *
  • Posts: 1
« on: March 20, 2014, 08:57:17 AM »

good day, I had a problem with my dcs-930L camera, which can not connect to the network, I have restored the factory settings the same with the reset button, but when I get to set the password tells me the following phrase "a problem occurred while saving changes. then click Next to try again" I restarted many times the camera I tried this several times but without success also. I hope you can help me. regards

Matias Olsen


  • BETA Tester
  • Level 15 Member
  • *
  • Posts: 12190
  • D-Link Global Forum Moderator
    • FoundFootageCritic
Re: dcs-930l
« Reply #1 on: March 20, 2014, 09:24:13 AM »

what firmware version are you using?
Are you using the Setup Wizard that came with the camera or a version you downloaded from D-Link?
Find answers here: D-Link ShareCenter FAQ I D-Link Network Camera FAQ
There's no such thing as too many backups FFC


  • Level 1 Member
  • *
  • Posts: 21
Re: dcs-930l
« Reply #2 on: March 20, 2014, 01:04:13 PM »

I had this issue and it was either a firmare / install software version mismatch or a problem with saving the password. Most likely it is the mismatch. However if they match, use the WPS button.