• October 19, 2019, 03:08:40 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DNS problem | Acces Control  (Read 2278 times)

BigBoyFoF

  • Level 1 Member
  • *
  • Posts: 1
DNS problem | Acces Control
« on: December 14, 2013, 02:37:42 PM »

Hello,

i'm a new owner of a Dlink DIR-868L.

I have some problem that is have to plug out the power every day beaceaus my DNS on the dir-868L is some how not correct. When i don't have internet i check DNS on Device info then i get the next info.

IP Address: 192.168.0.170
Subnet Mask : 255.255.255.0
Default Gateway: 192.168.0.1
Primary DNS Server : 192.168.0.1
Secondary DNS Server :

after pulling him out of the power i get a good DNS of my isp. Already disabled DNSrelay but that doesn't seem to work. Before i had a DIR-635 didn't have this problem ?

On ACCES CONTROL page i made some rules to block all acces for some hours for the kids. But it seem not to be solid ? XBOX360 stay whit full access and the ip is setup well on the acces control. The PC's on that same rule are blocked :/
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47844
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DNS problem | Acces Control
« Reply #1 on: December 14, 2013, 02:44:27 PM »

Link>Welcome!

  • What Hardware version is your router? Look at sticker under router.
  • Link>What Firmware version is currently loaded? Found on the routers web page under status.
  • What region are you located?


Internet Service Provider and Modem Configurations
  • What ISP Service do you have? Cable or DSL?
  • What ISP Modem Mfr. and model # do you have?
  • What ISP Modem service link speeds UP and Down do you have?
  • Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values
  • For DSL/PPPoE connections on the router, ensure that "Always ON" option is enabled.

Router and Wired Configurations
Some things to try: - Log into the routers web page at 192.168.0.1. Use IE, Opera or FF to manage the router.
  • Turn off ALL QoS or Disable Traffic Shaping (DIR only) GameFuel (DGL only and if ON.) options, Advanced/QoS or Gamefuel.
  • Turn off Advanced DNS Services if you have this option under Setup/Internet/Manual or under Setup/PARENTAL CONTROL/Set to>None: Static IP or Obtain Automatically From ISP.
  • Enable Use Unicasting (compatibility for some ISP DHCP Servers) under Setup/Internet/Manual.
  • Turn on/off DNS Relay under Setup/Networking. Link>Finding Faster DNS Addresses using Name Bench
  • Setup DHCP reserved IP addresses for all devices ON the router. Setup/Networking. This ensures each devices gets its own IP address when turned on and connected, eliminates IP address conflicts and helps in troubleshooting.
  • Ensure devices are set to auto obtain an IP address.
  • If IPv6 is an option on the router, select Local Connection Only or Disable IPv6 options under Setup/IPv6.
  • Set Firewall settings to Endpoint Independent for TCP and UDP under Advanced/Firewall. Enable or Disable SPI to test.
  • Enable uPnP and Multi-cast Streaming under Advanced/Networking. Disable uPnP for testing Port Forwarding rules. Enable IPv6 Multi-cast Streaming for routers that have a Media Server option. Disable IPv6 Multi-cast Streaming if IPv6 or Media Server is not being used.
  • Turn off WISH, and WPS under Advanced.
  • WAN Port Speed set to Auto or specific speed? Some newer ISP modems support 1000Mb so manually setting to Gb speeds can be supported by the router. Advanced/Advanced Networking/WAN Port Speed
  • Set current Time Zone, Date and Time. Use an NTP Server feature. Tools/Time.
Logged
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting