• November 04, 2024, 09:41:38 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DIR-655 in (Access Point) Mode - How to do it properly  (Read 27094 times)

NevTheTech

  • Level 1 Member
  • *
  • Posts: 1
DIR-655 in (Access Point) Mode - How to do it properly
« on: November 28, 2012, 12:51:11 PM »

OK, this is tested on Rev A1/A2.

Download Firmware 1.03 :

ftp://ftp.dlink.com/Gateway/dir655/Firmware/dir655_firmware_103.bin

And whatever firmware you want to run



Update the 655 to 1.03 and reboot. This will reset all settings to defaults. Don't bother saving them yet.
Go in and completely set up the 655 as you want it for acting in bridge mode.
When all settings are done and saved and rebooted (if necessary), set to Bridge mode and save settings and reboot. Now go in, set the Internet settings to point to your Modem/router and save the settings and reboot. Now save the setup to a file.
Now load your chosen firmware and reboot.
Go in and load your saved setup file. Reboot.

Done.
Mine worked with 1.35EU Firmware, but I tested it with a few in between and they all worked great. So you can get whatever speed or bug fixes are in your favourite Firmware, but use the 655 as a really good WiFi and network access point.

Not sure if this will help anybody now, but I googled this and got a load of pages that use one of the rj45 sockets to plug your modem into, rather than the WAN port. So here you go, for posterity if nothing else.



 
« Last Edit: February 25, 2015, 08:42:59 AM by FurryNutz »
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DIR-655 in (Access Point) Mode - Rev A Only!
« Reply #1 on: November 28, 2012, 01:31:32 PM »

Thank you for sharing your information.

FYI, this is only for Rev A units and only at this FW version level as Bridge mode was removed from later versions of Rev A FW and is not in Rev B FW versions.

There is no official down grade path for users of FW v1.2x and v1.3x and is not supported.

Please review this for correct usage of routers and bridgeable DLink model products:
Bridge Mode vs Relay vs Acess Point (AP) / Routers vs Dedicated Access Points (AP)

« Last Edit: February 25, 2015, 08:41:44 AM by FurryNutz »
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.