• June 04, 2024, 06:59:17 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: 404 - Not Found  (Read 5001 times)

Bojangly

  • Level 1 Member
  • *
  • Posts: 2
404 - Not Found
« on: August 29, 2012, 06:58:38 PM »

Has anyone else seen the following error while using the 505:

On an ipad,
Surfing in safari,
Connected to the strong signal of a Dir-505 configured as a repeater, "repeating" the wifi network of a Dir-825 router on the net via PPPoE.

For a short period of time, no matter what URL I go to, the resulting page says:

404 - Not Found

Or it actually takes me to the Dir-505 Admin Server.
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: 404 - Not Found
« Reply #1 on: October 02, 2012, 07:10:08 AM »

Any more information on this?

How are you connecting the 505 in repeater mode? Is there a host router that your using or is this a public place?
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

holmes4

  • Level 3 Member
  • ***
  • Posts: 123
Re: 404 - Not Found
« Reply #2 on: October 02, 2012, 07:20:35 AM »

I find that my 505 tends to reboot itself every 10-15 minutes in hotspot mode - have not really used repeater mode much, but there may be some similarities.  I'll get the behavior you describe when this happens.
Logged

holmes4

  • Level 3 Member
  • ***
  • Posts: 123
Re: 404 - Not Found
« Reply #3 on: October 19, 2012, 05:31:34 PM »

Supposedly, the new 1.04 firmware fixes this problem.  I am testing it now.  Be sure to do a "reset to factory" (push pin in hole below Ethernet jack and hold until the LED turns red) after upgrading, or else, I found, nothing works right.
Logged