I have bought an DWL-2100 AP. The AP runs in "Client" mode. The Ethernet interface has been connected in a switch (simple - 16 ports). I am facing the following issue. The first 3 PCs that has been connected on switch have full network activity. The next two have limitations. I have already add from CLI the command "set matstate 1" or "set matstate 2". The "set matstate 1" command solve the issue of 1 PC (I have this issue at the beginning).
Could you inform me if needed some extra configurations ?
Which "set matstate" command is the correct for "Client Mode" ?
Also, please inform me if any limitations (in the number of the clients) exist in "Client mode".
Note, that the Dlink has been successfully connected as client in a separate AP.
Please don't hesitate to ask me if you have any assumptions about my configuration.