• September 23, 2019, 10:22:29 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: WAN Status shows NA  (Read 1858 times)

dsmart

  • Level 1 Member
  • *
  • Posts: 1
WAN Status shows NA
« on: August 06, 2011, 02:15:16 PM »

I updated the firmware of my DIR601 to 1.02NA, it now only show NA under status for WAN, even though its connected (PPPoE).  It worked with 1.01NA.  I tried rebooting the router but no effect.

-=Dan=-
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47768
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: WAN Status shows NA
« Reply #1 on: August 06, 2011, 02:17:35 PM »

What ISP Service do you have? Cable or DSL?
What ISP Modem do you have? Stand Alone or built in router?
What ISP Modem make and model do you have?

After you updated the router and power cycled the router, did you also power of the ISP modem too then power on the ISP modem. Then power on the router?
Logged
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting