Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[robertMN]

I just set up the dir-655 yesterday.  My actiontec modem uses 192.168.0.1 for the ip address, so to avoid a conflict I changed the dir-655 ip address to 192.168.1.1.
With my old Linksys router, I was able to see the modem in the browser, now I am unable to see it.
Any suggestions?

Thanks

[jasqid]

Try just typing "dlinkrouter" in the address bar.

It sounds like you are going through a double NAT. You may have to config the modem to pass the WAN IP address. I had to do this for a customer that uses ATT DSL with the Motorola Modem.

[robertMN]

Try just typing "dlinkrouter" in the address bar.

It sounds like you are going through a double NAT. You may have to config the modem to pass the WAN IP address. I had to do this for a customer that uses ATT DSL with the Motorola Modem.

Thanks for the information.  dlinkrouter brings up the router; I can do that with the ip address of the router.
I plugged the modem directly into my pc and can see the modem.  Not sure how to pass the wan IP.  Nothing was apparent.  I am using Qwest and ppoe (?).  As long as I have a work-around it is ok as is.

[Sammydad1]

you can often set the dsl modem for bypass mode and use the DIR-655 for the PPPoE login to your ISP....