Using Dir-600 Firmware 2.03:
When setting up the router if I use just the plain DHCP set up using my information. I can then log on wirelessly with one computer to the VPN service. (Until today that worked fine.) When attempting to follow the ISPs instructions for setting up the dual access PPTP for D'Link routers I could now connect with any of the computers. A constant error with PAP seemed to present itself.
Will this cause any major problems? I'm sure it is not recommended, but I'm at my wits end.
Where do you see this error? Either DIR-600 or you PC
Forget with dd-wrt, to complex to support from outside.
We can arrange a web meeting, let's have a look on your configuration remotely.
Have you read my personal mail. Just come back to me.
Greetings to Russia (Kiew I would guess) from Stuttgart!
Update:
Try this on the Internst Connection Setup Page of your DIR-600.
If this is also not working, use CLONE MaC Address.
I can sen'r screenshots on request.
DIR-300 / 600 using Russion pptp
Enter the information provided by your Internet Service Provider (ISP).
:*:Dynamic IP Static IP
IP Address : (assigned by your ISP)
Subnet Mask :
Gateway :
DNS :
MAC Address : - - - - - (optional)
Server IP/Name :
PPTP Account :<username> MPPE :*:
PPTP Password : <password>
PPTP Confirm Password : password>
Maximum Idle Time : Minutes
MTU :1400:
Connect mode select :*: Always
: : Manual : : Connect-on demand
F41THR