Hello
I initially had one D-link 655 (referred to as Master) in my house which had poor coverage on second floor. So I installed a second d-link 655 as access point (referred to as Slave) on the second floor. The wireless range was extended and I can connect via internet wirellessly. Problem is that I cannot access internet when connecting a computer via cable to the Slave.
I have a NAS disk connected to the Master via a Switch. I can access the NAS from the computer when it is connected to the Slave. So it is only internet connection that is missing.
Other computers conntected directly to the switch has both NAS access and internet access i should say.
A schematic drawing
NAS
|
|
Zyxel ADSL Modem ---- Master 655---- Switch --- Slave 655
|
|
Computer
I have connected the Slave according to the following
cable from Master is connected to the LAN port of the Slave
Master has DHCP enabled
Slave has DHCP disabled
Slave and Master have same SSID (although I changed them temporarily when verifying that I got wireless internet via the Slave)
Master is running on channel 1 and Slave on channel 11
Master has IP 192.168.0.1 and subnet mask 255.255.255.0
Slave has IP 192.168.0.2 and subnet mask 255.255.255.0
Can someone please give a hint or advice what could be wrong.