D-Link Wireless Routers for Home and Small Business > DIR-869

Can't find the schedule in the 'Extender' menu

(1/2) > >>

manikma1:
Hello everyone - I got the 869 couple of months ago, and using it as my WiFi access point, connected with an ethernet on my main DSL router.
All good so far, until I started going around the menu the last days and it popped up that a 'new' firmware (1.02) can be installed.
Thus, I went ahead, and upgraded.
However, after that, in the 'Extender' menu where I am supposed to confi the 2 WiFis (2.4 and 5) I can no longer find and set the schedule based on which I want to disable any of the two Wifis during the week days.
Here is below the list of config items available for the 2.4, and similar are the ones for the Wifi 5.
But as you may see, there is no where anymore the 'Schedule'

Anyone with  similar issue which was finally fixed? Any suggestion/resolution already out there ?
Thank you in advance,
manikma


Status: Enabled
Wi-Fi Name (SSID): ABCDEF
Security:   WPA/WPA2-Personal
Password:   @#$@^#$^%$
802.11 Mode:   Mixed 802.11b/g/n
Wi-Fi Channel:   Auto
Channel Width:   Auto 20/40 MHz
HT20/40 coexistence:Enabled

FurryNutz:
Link>Welcome!


* What region are you located?
* Are you wired or wireless connected to the router?
* Has a Factory Reset been performed?
* Was a Factory Reset performed before and after any firmware updates then set up from scratch?  Link> >FW Update Process

* Was the router working before any firmware updates?
Internet Service Provider and Modem Configurations

* What ISP Modem Mfr. and model # do you have?
Doing FW update may revert the configuration back to default settings so you may need to do a factory reset and set up from scratch...

manikma1:

--- Quote from: FurryNutz on September 15, 2018, 11:30:24 AM ---Link>Welcome!


* What region are you located?EU, Greece


* Are you wired or wireless connected to the router?Wired


* Has a Factory Reset been performed?
Not yet


* Was a Factory Reset performed before and after any firmware updates then set up from scratch?  Link> >FW Update Process
No


* Was the router working before any firmware updates?Yes

Internet Service Provider and Modem Configurations
COSMOTE


* What ISP Modem Mfr. and model # do you have?ZTE Entry 2i

Doing FW update may revert the configuration back to default settings so you may need to do a factory reset and set up from scratch...

--- End quote ---
Oh nooooo.......

FurryNutz:
Let us know if factory reset and setup the 869 again from scratch and the extender menu should be seen here...

manikma1:

--- Quote from: FurryNutz on September 15, 2018, 11:49:20 AM ---Let us know if factory reset and setup the 869 again from scratch and the extender menu should be seen here...

--- End quote ---

Unfortunately, factory reset did not fix the issue.
Schedule field in the Extender menu does not exist.

Any more ideas? Or should I return it back ?

Navigation

[0] Message Index

[#] Next page

Go to full version