• September 28, 2023, 04:53:10 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DSR 500 static DNS does not work from my machine  (Read 7616 times)


  • Level 1 Member
  • *
  • Posts: 1
DSR 500 static DNS does not work from my machine
« on: December 15, 2017, 02:24:11 AM »

 A DSR500 route, Setup Static DNS. Can access the static DNS network in route. But can not access from a machine which under the router.
DSR500 LAN:;, gateway: second router WAN2 use IP to connect to DSR500 lan Static DNS: dest:; mask; gateway:

in the DSR500 to ping is ok. my machine ip is which can not ping

Any other configurations need to setup? I used DSR250 for static DNS. it simple to setup and work fine.


  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DSR 500 static DNS does not work from my machine
« Reply #1 on: January 02, 2018, 01:14:22 PM »


  • What Hardware version is your router? Look at sticker under the router case.
  • Link>What Firmware version is currently loaded? Found on the routers web page under status.
  • What region are you located?

Internet Service Provider and Modem Configurations
  • What ISP Service do you have? Cable or DSL?
  • What ISP Modem Mfr. and model # do you have?

Usually you can't access resources across different sub nets or networks. Might check the user manual for some Route configuration information that could be used.
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.