• November 22, 2019, 11:53:49 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Setting up new DNS-323 - need basic walk thru  (Read 3560 times)

randym431

  • Level 1 Member
  • *
  • Posts: 17
Setting up new DNS-323 - need basic walk thru
« on: December 03, 2007, 08:58:14 AM »

First, Im using vista prem 32 os.  I have two drives in the dns323, 320gb and 500gb. I downloaded the latest easysearch and it found the unit and assigned ip. However, when I select the ip, the config is still grayed out. And no drives listed. So I typed the ip address and got access to the units config menu.
From there I updated the firmware to the latest, and formatted the two drives. That all went well.
Now, I need a walk thru to get it showing as drive(s) in a network using vista.
Also, I notice in the easysearch, I have the two drives listed with "assign drive letter" to the right, but after selecting a drive, the "connect" and "disconnect" are still grayed out (non changeable or selectable).
Logged

randym431

  • Level 1 Member
  • *
  • Posts: 17
Re: Setting up new DNS-323 - need basic walk thru
« Reply #1 on: December 03, 2007, 07:08:27 PM »

Never mind.
Success by using network magic and a wired network line to the pc. I was originally using wireless.
Not sure which change made it go, but network magic made it easy to config things.
And the dsn323 drives then were connectable and assignable.
Logged