D-Link Enterprise Firewall > D-Link NetDefend Firewalls

DFL-210 Can't remote into network

(1/1)

krhoover:
I am trying to configure a DFL-210 to allow for rdp access to a certain computer on the network. All internal routing is done through a managed switch (HP-2920) that handles several VLANs. Every configuration I have tried gives the error that the "computer can't be found on the network". I know I have Remote Desktop set up correctly on the target computer, but I can't figure out how to access it from outside the firewall.  I could use any help I can get, as I am not familiar with programing firewalls. I don't know how to attach a file to this thread, but can send if if I know where.

FurryNutz:
Any status on this?

I presume RDP would be using something like ##.##.###.###:RDP Port#. The IP address being the Public/WAN IP address of the MODEM or Router that your network is connected too.

Navigation

[0] Message Index

Go to full version