• December 04, 2020, 06:46:52 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Ack, I pushed 'Scan Camera'  (Read 1205 times)

cathrynm

  • Level 1 Member
  • *
  • Posts: 1
Ack, I pushed 'Scan Camera'
« on: September 04, 2016, 04:20:37 PM »

And it wiped out all my cameras.  Ugh, how do you add cameras to this thing?  All the instructions are confusing, refer to some other UI.
Logged

BAMoh

  • Level 3 Member
  • ***
  • Posts: 303
Re: Ack, I pushed 'Scan Camera'
« Reply #1 on: September 04, 2016, 05:10:24 PM »

Its better to add cams via the GUI rather than the setup wizard. Not sure what you are using. Get the device setup except for the cams then add them via the GUI.
Logged
"That's laughable...."  Impress me. Need COMPETENT help.

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49378
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Ack, I pushed 'Scan Camera'
« Reply #2 on: September 06, 2016, 06:45:56 AM »

Link>Welcome!

  • What Hardware version is your DNS? Look at the sticker behind or under the device.
  • Link>What Firmware version is currently loaded? Found on the DNSs web page under status.
  • What region are you located?

You can log into the DNRs web page and configure cameras there...

And it wiped out all my cameras.  Ugh, how do you add cameras to this thing?  All the instructions are confusing, refer to some other UI.
Logged
Cable: 1Gb/50Mb>NetGear CAX80>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.