• January 22, 2021, 05:55:46 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DGS-1210-48 Ports aggregation/separation  (Read 4588 times)


  • Level 1 Member
  • *
  • Posts: 1
DGS-1210-48 Ports aggregation/separation
« on: June 16, 2016, 12:56:21 AM »

Hey guys,

First at all i would like to apologize if my question is too dumb... :)
I want to separate aggregate switch by two, for example i used all 48 ports like     Untagged VLAN Ports by default configuration, but i need to use port 33,34,35 and 36 in separated vlan again untaged , the reason that i want  to do that is because i have 2 dhcp servers for different network and i dont  want they are "talk" between. The most obvious way to do this is through a different(separated)  switch and physically aggregation, but if its possible to be use only one will be the best .

Best Regards, and appreciate any help



  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49465
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DGS-1210-48 Ports aggregation/separation
« Reply #1 on: September 16, 2016, 08:28:00 AM »

Any status on this ?
Cable: 1Gb/50Mb>NetGear CAX80>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.