• December 02, 2020, 05:48:35 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Setup a preset position after power up again?  (Read 1072 times)

hophuoc

  • Level 1 Member
  • *
  • Posts: 2
Setup a preset position after power up again?
« on: January 20, 2016, 08:15:37 AM »

Hi,
My camera is DCS-5222LB1, hardware ver B, firmware 2.11.01
After power down and power up again, the camera runs PTZ to a initial position automatically.
I wish the camera will automatically do PTZ to a preset position that it memorized( I setup before ie: home position) , Not to initial position after re- power.

How can I setup?

Best regards
Thank you

Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49375
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Setup a preset position after power up again?
« Reply #1 on: February 08, 2016, 07:10:37 AM »

This maybe default settings used for PTZ. You might look in the user manual to see if PTZ can be set to a custom setting, if not then it's by default.
Logged
Cable: 1Gb/50Mb>NetGear CAX80>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.