• November 21, 2019, 09:13:44 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: IPv6 Support  (Read 2882 times)

drshock

  • Level 2 Member
  • **
  • Posts: 52
IPv6 Support
« on: September 13, 2015, 08:10:39 AM »

I have a DAP-1522 rev A1 with last firmware available installed, 1.42.    I did not replace it when switching over to IPv6 because this D-Link list at the bottom Q&A states it supports IPv6 - http://us.dlink.com/technology/dlink-ipv6-solutions/

I noticed I do not see the IPv6 configuration options in my firmware UI that are shown starting on page 24 here either - http://www.dlink.com/-/media/Consumer_Products/DAP/DAP%201522/Manual/DAP%201522_Manual_EN_US.pdf

Is it possible that only the rev B hardware supports IPv6 and not the A rev?  If so, this should be clarified at the D-Link USA support site.
Logged
Live for today....

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47921
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: IPv6 Support
« Reply #1 on: September 13, 2015, 10:49:43 AM »

The DAP-1522 is based on similar HW as the DIR-655 Rev A. Both were succeeded with Rev B versions as well and I know that Rev B 655 supported IPv6. Rev A did not and I presume that Rev A DAP-1522 is the same. Most Rev A models of that time frame did not support IPv6.
Logged
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting