The Graveyard - Products No Longer Supported > DIR-855

Packet received but there is no active connection


DIR-855, I get this in my logs, "packet received but there is no active connection".  This is causing TIVO to not be able to connect, what is causing this, I did a factory reset and I still see this in the logs?


* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
* Are you wired or wireless connected to the router?

Internet Service Provider and Modem Configurations

* What ISP Service do you have? Cable or DSL?
* What ISP Modem Mfr. and model # do you have?
* Is ISP Modem/Service using Dynamic or Static WAN IP addressing?
* What ISP Modem service link speeds UP and Down do you have? Link> Speed Testing Sites
* By-pass the main host router and check internet connection by connecting a wired LAN PC directly to the ISP modem to verify connection access and ISP speeds.
* Check cable between Modem and Router, swap out to be sure. Link> Cat6 is recommended.
* Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values


[0] Message Index

Go to full version