• November 19, 2019, 05:17:03 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Use NAS as 2 port bridge  (Read 379 times)


  • Level 1 Member
  • *
  • Posts: 1
Use NAS as 2 port bridge
« on: September 12, 2019, 01:00:49 PM »


First thanks for the forum as it's a very nice place with a lot of resources about D-Link devices.

The question is very simple,

Is it possible to connect the NAS in this way?
LAN1: Ethernet port (Wall port to router, Internet, local network).
LAN2: Laptop.

I tried different network configurations without any luck.

The idea is basically to reduce the number of devices as I will like to avoid installing another switch.



  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47912
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Use NAS as 2 port bridge
« Reply #1 on: September 12, 2019, 03:36:50 PM »

The 2 ports on the back are used with Link Aggregation is enabled. Both ports would be connected to a LAG enabled router or switch in this configuration. If thats not enabled, then you'll need use either port and connect it to a switch.
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting