• September 20, 2019, 09:33:40 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DSL2750u C1 IN_1.10 - Invalid PCR value  (Read 1946 times)

vikrantkorde

  • Level 1 Member
  • *
  • Posts: 2
DSL2750u C1 IN_1.10 - Invalid PCR value
« on: February 25, 2015, 08:43:12 PM »

Hi,

I have recently bought a modem DSL 2750u C1 from Flipcart in India. The router is having IN_1.10 firmware installed in it.
First of all this firmware has pathetic GUI. The older version which i used IN_1.02 was much better.

I wanted to configure a connection for Joister ISP. They have PPPoE broadband. So i created EoA type ATM connection. If i user service type as "UBR with PCR" then it shows a text box for PCR (Peak Cell Rate) value. Whatever value i enter there, it shows "Peak cell rate must be in [0-1]". I can not leave it blank as it is mandatory. I am not bale to create the connection. This seems to be an issue with IN_1.10 firmware.

Please help.

Regards,
Vikrant Korde.
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47763
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DSL2750u C1 IN_1.10 - Invalid PCR value
« Reply #1 on: February 26, 2015, 06:57:58 AM »

I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this. We find that phone contact has better immediate results over using email. Might ask to see if you can down grade. If the prior version worked then maybe you can get it back. If it worked, then I don't recommend upgrading FW unless directed to.
Logged
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting