D-Link VPN Router > DSR-250N

Guest network can access gui

(1/2) > >>

StanKoek:
Hello,

I recently found out my guest network on the D-Link dsr-250n can access the GUI.
I tried to find the problem myself with no luck, also searched for it on the web with also no success.
Also left a message at D-Link website asking how to do this, now been one week and still no reply.
So my question is: How can i disable the GUI to the guest network while still able to connect to it by the company network?
Hope one of u here can help me out.

Thanks,
Stan

FurryNutz:
Link>Welcome!


* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
We find that phone contact has better immediate results over using email.

StanKoek:
Thanks for the reply,

    What Hardware version is your router? Look at sticker under the router case.
Hardware version A1
    Link>What Firmware version is currently loaded? Found on the routers web page under status.
Firmware version 1.08B39_WW
    What region are you located?
Netherlands, South Holland

Next time i'll call  ::)

thanks again,
Stan

FurryNutz:
I notice there is v1.09 B32 available for this model router. You might try it and see if it resolves this...

StanKoek:
Now running on Firmware Version: 1.09B32_WW.
no changes, guest can still access GUI. Any ideas?

Navigation

[0] Message Index

[#] Next page

Go to full version