• December 05, 2019, 05:21:58 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Configuration of DAP-2310  (Read 4258 times)

mpethe

  • Level 1 Member
  • *
  • Posts: 1
Configuration of DAP-2310
« on: November 26, 2014, 06:29:27 PM »

I'm guessing the config options are similar on the 2310 which I have 2 of.

I would simply like to deploy these in an office so that they have the same SSID and wireless clients can move seamlessly through the office space without getting disconnected.

After reading the manual I don't understand the differences between the configuration modes (Access Point, WDS+AP, WDS, AP Repeater). And then there's the AP array. They all seem like they would do what I want it to.

What should I be using here?

Thanks!
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47953
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Configuration of DAP-2310
« Reply #1 on: December 08, 2014, 06:52:49 AM »

Some Info:
Bridge Mode vs Relay vs Access Point (AP) / Routers vs Dedicated Access Points (AP)

Review Wikipedia for additional information as well.

Logged
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47953
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Configuration of DAP-2310
« Reply #2 on: April 24, 2015, 08:01:26 AM »

Any status on this?  ???

I'm guessing the config options are similar on the 2310 which I have 2 of.

I would simply like to deploy these in an office so that they have the same SSID and wireless clients can move seamlessly through the office space without getting disconnected.

After reading the manual I don't understand the differences between the configuration modes (Access Point, WDS+AP, WDS, AP Repeater). And then there's the AP array. They all seem like they would do what I want it to.

What should I be using here?

Thanks!
Logged
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting