• February 25, 2021, 12:30:05 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Good Day  (Read 2758 times)

codedhandrew

  • Level 1 Member
  • *
  • Posts: 1
Good Day
« on: February 01, 2013, 12:49:10 AM »

Plz i need an urgent assistance on how to setup my DAP 1360 Repeater i switched it on, what next should i do cos after i switched it on i went to the Browser and type 192.168.0.50 but didnt show me the admin page ..please what next steps are required after switching on the Repeater.... will need the steps on how to setup the repeater.

Thank you
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49521
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Good Day
« Reply #1 on: February 01, 2013, 07:23:23 AM »

I recommend that you factory reset the 1360 and then use the on board wizard to walk you thru setting up Repeater mode.
 
Ensure that if the DAP is not connected to any main host routers, that you need to set your PC that your using to manage the DAP to a static IP address of 192.168.0.49.

Then directly connect the PC via LAN cable to the back of the DAP and then you should be able to access the DAPs Web page at 192.168.0.50. I recommend using IE or FF to manage the DAP only.
Logged
Cable: 1Gb/50Mb>NetGear CAX80>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.