• May 28, 2020, 07:44:33 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Can you use HA with DMZ in transparent mode on a single port?  (Read 1763 times)

RanmaKei

  • Level 1 Member
  • *
  • Posts: 1
Can you use HA with DMZ in transparent mode on a single port?
« on: November 05, 2012, 06:22:24 PM »

Can you use HA with 'DMZ in transparent mode on a single port' while using NAT and vpn on another port?

Here is the setup I want to implement.

http://www.fuzeqna.com/sonicwallkb/consumer/kbdetail.asp?kbid=5979

I want to be able to VPN into the firewall either on the primary or the backup device in a HA Setup. Then be able to access the servers on the internal management network(10.51.10.1-10.51.10.254)[port X0]. On the DMZ [X2] I want to have transparent DMZ so that I have IPS protection for servers that will have their WAN NIC's set to a public IP address.
Logged

danilovav

  • Level 4 Member
  • ****
  • Posts: 424
  • Alexandr Danilov
Re: Can you use HA with DMZ in transparent mode on a single port?
« Reply #1 on: November 20, 2012, 01:11:01 PM »

Transparent mode itself will works in this configuration.

But, i'm not sure about HA.
Logged
BR, Alexandr Danilov

chechito

  • Level 3 Member
  • ***
  • Posts: 193
Re: Can you use HA with DMZ in transparent mode on a single port?
« Reply #2 on: December 01, 2012, 08:55:39 PM »

from firmware release notes:

Known Issues:
Firmware
Version
Known Issues
2.40.01
...
3. Transparent Mode won’t in HA mode.
Logged