• October 28, 2020, 08:21:54 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Possible failed fw update  (Read 5706 times)


  • Level 1 Member
  • *
  • Posts: 1
Possible failed fw update
« on: September 21, 2013, 06:30:33 PM »

Ok, so I have recently purchased a new Dlink DAP-1522 rev. B1 and was setting it up. After playing around with it for a while to get a hang of the features I reset to factory defaults. After this I set an admin password and then did the fw update from 2.02 to 2.04. After the reset I can get to the admin page but it tells me incorrect password or user name. I have tried both the blank default and also the password that I used prior to the update. Also now when doing the hard reset I am getting no change to the 'incorrect password'. Is there a way to do a fw update outside of the admin page or another way to reset to factory defaults? Thank you for your help


  • Level 3 Member
  • ***
  • Posts: 126
Re: Possible failed fw update
« Reply #1 on: September 21, 2013, 06:40:45 PM »

Try these emergency flash instructions.  Your ip will most likely be different and the default.



  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49296
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Possible failed fw update
« Reply #2 on: October 08, 2013, 07:05:23 AM »

Any status on this?
"Nothing Funny about It...." We are not here to Impress anyone! You have a be a COMPETENT user first to under stand COMPETENT help!