• October 24, 2020, 05:04:56 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Accessing DCS-930L's IP when it's connected to an access point...  (Read 2074 times)


  • Level 1 Member
  • *
  • Posts: 1

Maybe my brain is just not firing on all cylinders but I'm kind of stuck.
My network is setup like this.
I have an ActionTec Q1000 modem/router all in one.

Connected to the Q1000 via an ethernet cable I have a DEP-1522 wireless bridge setup as a access point, this is to extend the wireless signal into the living room since the Q1000s signal doesn't reach (it's in the far back bedroom).

I connected the DCS-930L camera to the DEP-1522 access point since the camera will be used in that part of the house. When I'm connected to the DEP-1522 access point, I can enter the camera's IP address and it pops up no problem.

However if I am connected to the Q1000 and I enter the IP for the DCS-930L I get an error and nothing loads.

Is there a way to access the camera's IP when I'm connected to the Q1000 or will I always have to be connected to the DEP-1522?
Please help. I'm going to continue to play with it until I get frustrated.
Thanks in advance!