• October 12, 2024, 08:58:40 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Pages: 1 [2]

Author Topic: can I set 655 as just an access point or bridge???  (Read 40821 times)

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: can I set 655 as just an access point or bridge???
« Reply #15 on: February 01, 2012, 10:43:22 AM »

Enjoy.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

ktklein

  • Level 1 Member
  • *
  • Posts: 5
Re: can I set 655 as just an access point or bridge???
« Reply #16 on: February 03, 2012, 06:26:26 AM »

So to use the DIR-655 as an AP only, it must be wired via a CAT5/5e connection back to the "other" router device?  I have three floors on which I need coverage.  Currently my DIR-655 is on the main floor and my cable modem is next to it (in the entertainment center since the TV and BR player have wired connections for internet).  My upstairs coverage is fine, but the basement is weak.  What can I put down there to act as a repeater so I can have a solid signal down there too?  I was thinking if I got a newer router than I would just use the DIR-655 to do that, but it seems like you are saying that is not possible.  Given that fact, rather than replacing the DIR-655 as my primary router, if I leave it in place as is, what can I put in the basement that will not require a wired connection (other than power of course)?  Thanks.
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: can I set 655 as just an access point or bridge???
« Reply #17 on: February 03, 2012, 06:45:32 AM »

Yes you can use the 655 as an AP wired including CAT 6 which is preferred. However you have a couple of open options available as well. Get a DAP model device that support repeating function or use the power line LAN devices that connect thru the v110 power lines and get Internet to where its needed. I do prefer the AP as it can provide the best stability for wireless since it has a wired connection. However that kind of depends on cable runs and how you can manage to get a wire installed with out too much hassle. Sometimes running a wired outside the building and back in can work. If this isn't a viable option then of course, using a repeating devices or the power line devices will work as an alternative.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

ktklein

  • Level 1 Member
  • *
  • Posts: 5
Re: can I set 655 as just an access point or bridge???
« Reply #18 on: February 03, 2012, 07:27:01 AM »

Right now I have my PC in an office in the basement and eventually when we finish redoing the basement, a new TV and my son's XBox360 will alos be down there.  My PC has a wired Gig/E port and I also have a DWA-160 wireless adapter.  I think installing a repeater is my best option so I don't have to purchase multiple power line adapterss.  I had considered that for my PC but when talk of moving the XBox came up I started thinking extending the wireless signal was my better option overall.
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: can I set 655 as just an access point or bridge???
« Reply #19 on: February 03, 2012, 07:50:59 AM »

Be aware that a wired connection is best for the xbox if you can do that.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

bobinmi

  • Level 1 Member
  • *
  • Posts: 1
Re: can I set 655 as just an access point or bridge???
« Reply #20 on: April 02, 2012, 07:33:07 PM »

I have two old US Robotic routers (USR5461). I have one attached to my cable modem, and that router is  wirelessly connected to my second router. As they are in separate buildings, I cannot use a cable between them. Today I bought two DIR-655s intending to do the same thing except at a much higher speed, etc. From what I read here, it appears that they will only work togeather if linked by cable. HOW CAN THIS BE???? The USR's are old and they can connect wirelessly with each other. This is just unbelievable. Someone please tell me that my conclusions are wrong.
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: can I set 655 as just an access point or bridge???
« Reply #21 on: April 02, 2012, 07:41:20 PM »

The DIR series of routers are just that, ROUTERS not wifi repeaters or bridged. DIR series routers do not support repeating or bridged modes. They can't be turned into APs however that requires a wired connection to the back. If you need a repeater or bridge function then you need DAP-1360 or 1522 model units for this.

Bridge Mode vs Relay vs Acess Point (AP) / Routers vs Dedicated Acess Points (AP)
« Last Edit: February 26, 2015, 01:02:07 PM by FurryNutz »
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

Schmye Bubbula

  • Level 2 Member
  • **
  • Posts: 31
Re: can I set 655 as just an access point or bridge???
« Reply #22 on: January 09, 2013, 10:34:04 AM »

I'm new to this, so please be gentle. After reading this thread and the FAQ, do I understand correctly that I can get a D-Link DIR-505, set it up to access wirelessly my main router upstairs connected to a cable/DSL modem, then plug my DIR-655 into the DIR-505 with an Ethernet cable (so that my downstairs devices will run off the DIR-655)?

If so, does the DIR-655 have to connect wired to the DIR-505 (not a problem; just curious), or is it also able to connect wirelessly?
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: can I set 655 as just an access point or bridge???
« Reply #23 on: January 09, 2013, 10:35:13 AM »

The 655 would need to be wired and you would need to configure the 655 using this:
Turning a router into an AP.
« Last Edit: February 26, 2015, 01:01:54 PM by FurryNutz »
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

tradermarco

  • Level 1 Member
  • *
  • Posts: 1
Re: can I set 655 as just an access point or bridge???
« Reply #24 on: February 19, 2013, 02:01:23 PM »

Anybody know a work around to use Guest Zone in AP - Access Point mode? That is to say, Have Internet access only without access to LAN (Enable Routing Between Zones box UNCHECKED) . Can I do this buy attaching another AP device?
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: can I set 655 as just an access point or bridge???
« Reply #25 on: February 19, 2013, 02:07:00 PM »

Guest Zone would not be used as it's dependent upon the WAN port being used. If the 655 is running in AP mode wired to another main host router using the LAN port only, then Guest Zone needs to be disabled.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.
Pages: 1 [2]