• November 19, 2019, 04:23:46 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Degraded Array  (Read 3064 times)

mcz101

  • Level 1 Member
  • *
  • Posts: 7
Degraded Array
« on: December 12, 2008, 10:04:36 AM »

Ok, I just saw the right light blinking only on my nas. I go to the status and see that the RAID is degraded. However, the light on the left side is not purple like it should be. The drive was failing before until I did repairs on it. Now I guess it finally gave out on me. I just need to know how to check in fact that the drive is completely unusable? Normally when it says Degraded, I should see the purple light. It's still blue.
Logged

espiritu

  • Level 1 Member
  • *
  • Posts: 23
Re: Degraded Array
« Reply #1 on: December 12, 2008, 12:12:07 PM »

the best tool for checking drives is spinrite from www.grc.com in fact it can even repair bad portions of a drive but depending on your raid config you may need to pull the drive from the box and attach it to another computer to be scanned and spinrite needs direct access to the drive.

check the faq for the raid section http://www.grc.com/sr/faq.htm
Logged

ECF

  • Poweruser
  • Level 11 Member
  • *
  • Posts: 2692
Re: Degraded Array
« Reply #2 on: December 29, 2008, 11:46:55 AM »

Please try firmware 1.06 there is not an option to manual rebuild your RAID1 array if it becomes degraded.
Logged
Never forget that only dead fish swim with the stream