• October 20, 2019, 07:16:00 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DGL-4100 Router will send, but not receive XP SP3 (same with SP2)?  (Read 3638 times)

scottls

  • Level 1 Member
  • *
  • Posts: 2
DGL-4100 Router will send, but not receive XP SP3 (same with SP2)?
« on: September 13, 2010, 03:20:15 PM »

My new DGL-4100 (1.7) works good on my Win7 computer.

Problem?- XP on my other computer (fresh install"s"/bare) will send, but not receive until I do a Repair?
Reboot, and same no-receive problem comes back!?
I've reset my newer modem (Motorola SB6120)/router several times, and had 2 long sessions with D-Link support to no avail? I've also tried new cat 6 ethernet cables?
My settings are obtain IP automatically.

If I connect directly to my modem, XP connects with no problem.

Any suggestions would be appreciated?  ???
Logged

Jim1900

  • Level 1 Member
  • *
  • Posts: 2
Re: DGL-4100 Router will send, but not receive XP SP3 (same with SP2)?
« Reply #1 on: October 02, 2010, 05:54:09 PM »

It is probably some problem with the automatic speed negotiation.  Try setting your card manually to a fixed speed (e.g., 100 Mbps full duplex) in Device Manager/Properties/Advanced.
Logged

scottls

  • Level 1 Member
  • *
  • Posts: 2
Re: DGL-4100 Router will send, but not receive XP SP3 (same with SP2)?
« Reply #2 on: October 02, 2010, 08:58:10 PM »

Router also started having to be constantly reset on my Win 7 computer!?
I Googled, and found the solution (I first reset speed to 100mbps full duplex)!-


NOTE!- FIRST plug computer directly into modem!

Right click & Run Cmd.exe as "Run as Admin" (Vista/7, and NOT as normal logged in Admin!)

ipconfig /flushdns     (then press Enter)

then
 
ipconfig /renew          (then press Enter)

 then enter exit    
press Enter

~~~~~~~~~~~~~
BTW!- When installing "Trusted" programs in 7, I now always "Run as Admin" & temp disable my AV!
-After installing Puran Defrag 7.1!- I also had to run services.msc in "Run as Admin", in order to disable Win defrag!
« Last Edit: October 02, 2010, 09:59:19 PM by scottls »
Logged