• October 29, 2020, 07:13:56 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: How to set WAN IP  (Read 3887 times)

zdhr

  • Level 1 Member
  • *
  • Posts: 1
How to set WAN IP
« on: June 27, 2010, 10:52:21 PM »

Hello,

I cannot find WAN settings to set static IP obtained from my ISP. Is this possible?

(as an access point mode connected to internet using ethernet cable to cable modem)
« Last Edit: June 28, 2010, 04:13:39 AM by zdhr »
Logged

Guyon

  • Level 1 Member
  • *
  • Posts: 17
Re: How to set WAN IP
« Reply #1 on: April 24, 2011, 10:13:51 AM »

IF you have you DAP-1360 set as Access Point then:

1) If your ISP supplies an IP via DHCP  (Most likely)
Go into LAN settings and set it to Dynamic IP

2) If you have a static IP address from you ISP then
Go into LAN settings and set it to Static IP and add the address

IP Address :    
Subnet Mask :    
Gateway Address :    

3) You probably also need to enable DHCP Server addresses (same setup page) for internal IP addresses for multiple devices attaching to the DAP-1360.
Logged