D-Link VPN Router > DSR-1000AC

How to enable communication of devices from different VLANs


In my router (DSR-1000AC with Firmware 3.11_WW), I created a new VLAN 192.168.3.x following the instructions from HOW to Setup Two VLANS ‑ DSR‑Series.

I used a simple switch (not managed) and I connected it to port 4 of the router. Then, I connected a PC to this switch and it took successfully an IP from the new VLAN, the

Till here all good. However, this PC can't see the devices from the default VLAN 192.168.0.x (e.g. a network disk). The ping doesn't return anything..

The above guide notes that:

InterVLAN Routing can stay “Off” this way there is no way that both networks will see each other

So I turned in ON that setting. However, the devices from the 2 subnets can't "talk" each other. So my question is how can enable that?


* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
Are you sure the setting was enabled and saved and applied?
You might need to reboot the router, switch and PCs after making the change.

I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this.
Link> Tech Support Contact Information
We find that phone contact has better immediate results over using email.
Let us know how it goes please.

Fortunately, I figured out what I had missed to do...
I hadn't enabled that option in the default VLAN too.. I did it, restarted the router as you wrote and then my devices were view-able!

Thanks a lot!

Glad you figured it out. Thanks for letting us know. Enjoy.  ;)


[0] Message Index

Go to full version