D-Link VPN Router > DSR-500N

DSR-500N failover issue

(1/1)

adelmof:
im have an  dsr500 with same problem...



--- Quote from: anaghdesai on November 17, 2011, 09:51:32 PM ---I have a strange DSR-500N failover issue. When connected on both WAN1 and WAN2, it takes nearly 4 minutes incase of a failover. After extensive testing I somewhat managed to conclude that if there is any session which is going on, it fails to perform a successive failover (possibly due to some NAT issue). If there are absolutely no sessions going on (not even a ping) only then it manages within 30secs or so (but I cannot conclude the exact time as if i ping and the failover isnt complete then it takes more than 2 mins). Has anyone else experienced the same problem where it takes as long as 4 mins for a failover or am I going wrong with my configurations?

Firmware Version: 1.03B43_WW

Thanks

--- End quote ---

FurryNutz:
Link>Welcome!


* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
Internet Service Provider and Modem Configurations

* What ISP Service do you have? Cable or DSL?
* What ISP Modem Mfr. and model # do you have?
* Is ISP Modem/Service using Dynamic or Static WAN IP addressing?

Navigation

[0] Message Index

Go to full version