• October 20, 2019, 05:17:16 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DFL-210 Can't remote into network  (Read 2570 times)


  • Level 1 Member
  • *
  • Posts: 7
DFL-210 Can't remote into network
« on: April 02, 2017, 12:16:43 PM »

I am trying to configure a DFL-210 to allow for rdp access to a certain computer on the network. All internal routing is done through a managed switch (HP-2920) that handles several VLANs. Every configuration I have tried gives the error that the "computer can't be found on the network". I know I have Remote Desktop set up correctly on the target computer, but I can't figure out how to access it from outside the firewall.  I could use any help I can get, as I am not familiar with programing firewalls. I don't know how to attach a file to this thread, but can send if if I know where.



  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47844
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DFL-210 Can't remote into network
« Reply #1 on: April 07, 2017, 07:02:46 AM »

Any status on this?

I presume RDP would be using something like ##.##.###.###:RDP Port#. The IP address being the Public/WAN IP address of the MODEM or Router that your network is connected too.
Cable:200mb/10Mb>NetGear C7800>DIR-882>DGS-1100>HP 24pt Gb Switch. COVR-3902/2202/1203,DIR-2680,890L,882,880L,868L,DNR-202L,DNS-345x2,DCS-933L,936L and 960L.
Go Here>Router Troubleshooting