• April 25, 2019, 05:02:19 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DCS2100+ Emergency Firmware Update  (Read 756 times)

carloperatoner

  • Level 1 Member
  • *
  • Posts: 1
DCS2100+ Emergency Firmware Update
« on: March 24, 2017, 09:35:40 AM »

I have a DCS2100+ that I cannot configure.    When I use the IP installation wizard it shows a valid IP address, but the Assigned and Auto IP are tagged as No.   I can select Setup and walk thru the screens but it fails when i click on Finish with an error message - not a valid IP address.  I have reset a number of time with no change in behavior and tried to configure on another network.  I have 4 others so i am conversant on how to set them up properly.  The camera is probably functional but needs to have the firmware re-flashed.   

Is there a low-level process to re-flash the firmware.   I know some of the cameras have a specific IP address and timing from reset to get to a firmware flash page, but I have not found anything specific for these cameras.   I know that these cameras are repackaged Vivotek IP3133 cameras.   I have searched on their forum as well.   

Any help is appreciated.

Thanks in advance,

Carlo
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 47237
  • D-Link Global Forum Moderator
    • New DIR-890L Router with SmartConnect™ Technology
Re: DCS2100+ Emergency Firmware Update
« Reply #1 on: March 24, 2017, 01:57:28 PM »

Link>Welcome!

  • What Hardware version is your DCS? Look at the sticker behind or under the camera.
  • Link>What Firmware version is currently loaded? Found on the DCSs web page under status.
  • What region are you located?

What Mfr and model is the main host router?
What wireless modes are you using?

PC Web Browser Configurations
What browser are you using?
Try FF? If IE11, set compatibility mode and test again.

u]PC 3rd Party Security Software Configurations[/u]
  • Turn off all anti virus and firewall programs on PC while testing. 3rd party firewalls are not generally needed when using routers as they are effective on blocking malicious inbound traffic.

Try this:
Emergency Recovery Mode
Logged
"Nothing Funny about It...." We are not here to Impress anyone! You have a be a COMPETENT user first to under stand COMPETENT help!