The Graveyard - Products No Longer Supported > DIR-600M

Dlink DIR-600M

(1/1)

balu11698:
When I check ping in cmd by typing "ping 192.168.0.1 -t" through wifi the ping results are different . They are approximately 100ms difference. While i ping through cable all the results are 1ms. Need help.

FurryNutz:
Link>Welcome!


* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
* Are you wired or wireless connected to the router?
* Has a Factory Reset been performed?
* Was a Factory Reset performed before and after any firmware updates then set up from scratch?  Link> >FW Update Process

* Was the router working before any firmware updates?
Internet Service Provider and Modem Configurations

* What ISP Service do you have? Cable or DSL?
* What ISP Modem Mfr. and model # do you have?
It's not recommended to ping or speedtest via wireless as there are many factors and variables that contribute to inaccurate or bad results.

Wireless Configurations
Links>Wireless Installation Considerations and Managing Signal Congestion and Good Neighbour Policy

* What wireless modes are you using?
* Try single mode G or N or mixed G and N?
* Channel Width set for Auto 20/40Mhz or try 20Mhz only.
* Try setting a manual Channel to a open or unused channel. 1, 6 or 11. 11 for single mode N if the channel is clear. 13 for EU regions.
* What security mode are you using? Preferred security is WPA-Personal. WPA2/AES Only. Some WiFi adapters don't support AES, so you might want to try TPIK only or Auto TPIK and AES.
* What wireless devices do you have connected?
* Ensure any devices with WiFi adapter drivers are updated.
* Any 2.4Ghz or 5Ghz cordless house phones or WiFi APs near by that maybe causing interferences?
* Any other WiFi routers in the area that maybe causing interferences? Link> Use a WiFi Scanner to find out. How many?

Navigation

[0] Message Index

Go to full version