• August 17, 2019, 08:09:00 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DSN-3200 boot failure  (Read 5845 times)

spinunet

  • Level 1 Member
  • *
  • Posts: 1
DSN-3200 boot failure
« on: September 10, 2010, 06:25:20 PM »

I purchased a DSN-3200 in May 2010 and has been running ok until today.  I rec'd a somewhat cryptic email msg:

Severe event has happened on hn0000000063700034. Please check the event log for more information.

However, I wasn't able to logon, nor ping any interface.  I connected directly to the ethernet mgmt port and the was shown:



Please wait while the xStack Storage starts up

0 - Processing: Make RAM-disk directory
1 - Processing: Initialize signals
2 - Processing: Setup shared memory segment
3 - Processing: Get hardware info
4 - Processing: Reset 18K
5 - Processing: Open ichar device
6 - Processing: Initialize the system momory and Enable the Buffer Memory
7 - Processing: Create the Buffer memory block device and filesystem
8 - Processing: Run application - mytest2
9 - Processing: Install HACC driver
10 - Processing: Inialize Email Noticiation Thread
11 - Processing: Run application - msm
12 - Processing: Inialize MMSG socket
13 - Processing: Check the emp log file
14 - Processing: Run application - emp
15 - Processing: Skip starting emp -other
16 - Processing: Run application -isnsc
17 - Processing: Run zebra
18 - Processing: Run ripd
19 - Processing: Run application - cmapMain
20 - Processing: Initialize batter manager
21 - Processing: Run applicaiton - cimserver
22 - Processing: Run web server
23 - Processing: Run SSL web server
24 - Processing: Setup the 18K
25 - Processing: Load 18k firmware
26 - Processing: Start Proxy ARC
27 - Processing: Install ieth driver
28 - Processing: Run application - esa
29 - Processing: Run application - mytest2
30 - Processing: Run application = rcp
31 - Wait for Start 18K message

The system just hangs here, and does not continue booting.

I telnet'd into the xStack to reboot and restart, but both failed.

I powered it down several times and had the same results.  Has anybody else experienced this problem?

Thanks in advance
« Last Edit: September 10, 2010, 06:30:57 PM by spinunet »
Logged