D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-960L => Topic started by: Tunam on May 15, 2019, 04:59:03 PM

Title: Http command motion detection 960L
Post by: Tunam on May 15, 2019, 04:59:03 PM
Hello,

I allow myself to post because I can't activate the motion detection of my 960l (Ver: A1 Fw ver : 1.06.01) via an HTTP request. Indeed, I have a domitic box jeedom on a raspberry. And it already controls a C2 foscam via the same process.
While browsing the internet, I found this address that works if I am connected to my camera via my chrome browser:

http://(username):(password)@192.168.168.1.xx:xx/config/motion.cgi?enable=yes&sensitivity=80&mbmask=FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF

But I can't activate it via my jeedom. Do you have a solution for me? I made a mistake in syntax? or the camera just doesn't know how to do it?

Sorry about my English, I live in Belgium

Thank you for your answer.

Greg