D-Link Forums

The Graveyard - Products No Longer Supported => Routers => DIR-869 => Topic started by: yppy on April 14, 2019, 03:16:38 AM

Title: [DIR-869] Update failed => bricked
Post by: yppy on April 14, 2019, 03:16:38 AM
Hello D-Link,
I'm sending you this MAYDAY  :-\

Looks like my update didn't go well, as I can see my rooter is brick and it's impossible to join it.

I read every step I can find on the internet.
Whatever I try, I start the router I have a orange fixed led for 8 seconds then it start blinking (orange bliking).
Ethernet cable plugged into port N1. Manual IP is set 192.168.0.10 and I can't ping it
I tried everything with the reset switch (with a paper clip) nothing is working so far.
I used tcpdump to capture traffic with Wireshark, I can't see ARP request but nothing more...

Any idea will be greatly appreciated ! :)
Thanks for your help



Title: Re: [DIR-869] Update failed => bricked
Post by: FurryNutz on April 15, 2019, 06:53:55 AM
Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)


Please try this:
Emergency Recovery Mode (http://forums.dlink.com/index.php?topic=44909.msg163599#msg163599)

If this fails, I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this.
Link> Tech Support Contact Information (http://forums.dlink.com/index.php?board=635.0)
We find that phone contact has better immediate results over using email.
Let us know how it goes please.
Title: Re: [DIR-869] Update failed => bricked
Post by: yppy on April 22, 2019, 09:33:13 AM
Hello there,
sorry for the time to get my reply. Busy week.
So the sticker says:
H/W: A1
F/W ver: 1.01
Title: Re: [DIR-869] Update failed => bricked
Post by: FurryNutz on April 22, 2019, 10:56:11 AM
Let us know if the recovery method works...
Title: Re: [DIR-869] Update failed => bricked
Post by: yppy on April 22, 2019, 12:12:21 PM
As I said, already tried, nothing worked :(
Title: Re: [DIR-869] Update failed => bricked
Post by: FurryNutz on April 22, 2019, 12:14:39 PM
I would contact D-Link support.

Good Luck.
Title: Re: [DIR-869] Update failed => bricked
Post by: GreenBay42 on April 22, 2019, 12:30:53 PM
Did you try the recovery or just a reset?

If you plug a computer into a LAN port, do not statically assign it. Leave it DCHP. Can you release/renew an IP address?

Is anything plugged into the WAN port? If you have a modem/router, it may use 192.168.0.1 which would change the LAN IP address on the dlink router to 192.168.100.1.

If you statcally assign an IP, try http://dlinkrouter.local. instead of the IP address. Can you access it then?