D-Link Forums

D-Link Connected Home (mydlink Home devices) => DCH-S150 => Topic started by: mdizard on July 11, 2018, 08:21:26 PM

Title: Using the Schedule Function
Post by: mdizard on July 11, 2018, 08:21:26 PM
I have a bunch of these DCH-S150 sensors. I was using the Basic Schedule function on a half dozen of these and they were working great until the Firmware version 1.22. All Schedule function stopped working on all scheduled sensors. The sensor works fine if you manually turn it on and off. Has anyone else experienced similar problems?
Title: Re: Using the Schedule Function
Post by: FurryNutz on July 12, 2018, 06:57:29 AM
Try taking one of the sensors on do a factory reset on the sensor then set it up from scratch...re-configure the schedule feature and let us know if the problem still happens...
Title: Re: Using the Schedule Function
Post by: GreenBay42 on July 12, 2018, 07:04:48 AM
The scheduling issue has affected different Connected Home devices. D-Link is working on a fix. 
Title: Re: Using the Schedule Function
Post by: Gary7770 on July 18, 2018, 05:51:27 AM
Since these motion detectors are a very important part of my home security setup, is there a timeframe in place for getting this resolved?

Thanks,
Gary
Title: Re: Using the Schedule Function
Post by: GreenBay42 on July 18, 2018, 07:10:16 AM
No timeline yet. Make sure you contact tech support and report the issue.

There was BETA firmware for the smart plugs with the same issue released yesterday so hopefully they will have something for the other connected home devices. This issue is not affecting most customers.
Title: Re: Using the Schedule Function
Post by: gustavogarzasanchez on July 19, 2018, 08:40:06 AM
Hey, Gary7770.

Yeah, I have the same issue and factory reset does not work. I started a similar post here: http://forums.dlink.com/index.php?topic=73868.0 (http://forums.dlink.com/index.php?topic=73868.0)

I will report the issue as well.

BTW, did you ever tried the "Advanced Schedule"? I could never make it work.