D-Link Forums

The Graveyard - Products No Longer Supported => Routers => EBR-2310 => Topic started by: seanml on January 28, 2017, 09:43:05 PM

Title: EBR-2310 connection issues II
Post by: seanml on January 28, 2017, 09:43:05 PM
I have been getting similar issues with the same router. RCA/Thomson/Technicolor   TC4300
Cant seem to even go on there site. That is now the second problem other than constant disconnections.  Some pages work.

ISP is teksavvy modem just has one port it is
Firmware is update 2.01 Hardware Version: B1


"[INFO] Sat Jan 28 02:42:07 2017 Log viewed by IP address 192.168.0.101
[INFO] Sat Jan 28 02:41:59 2017 Blocked incoming TCP connection request from 192.81.135.222:47471 to 108.162.129.80:443
[INFO] Sat Jan 28 02:41:55 2017 Allowed configuration authentication by IP address 192.168.0.101
[INFO] Sat Jan 28 02:41:45 2017 Blocked incoming TCP connection request from 179.26.149.129:50032 to 108.162.129.80:23
[INFO] Sat Jan 28 02:40:55 2017 Blocked incoming TCP connection request from 116.96.196.116:16468 to 108.162.129.80:23
[INFO] Sat Jan 28 02:40:53 2017 Blocked incoming TCP connection request from 113.91.136.129:15951 to 108.162.129.80:22
[INFO] Sat Jan 28 02:40:41 2017 Blocked incoming TCP connection request from 125.127.137.6:58920 to 108.162.129.80:22
[INFO] Sat Jan 28 02:40:15 2017 Blocked incoming TCP connection request from 14.148.145.194:30077 to 108.162.129.80:23
[INFO] Sat Jan 28 02:40:12 2017 Blocked incoming TCP connection request from 115.233.217.117:24465 to 108.162.129.80:23
[INFO] Sat Jan 28 02:40:11 2017 Blocked incoming TCP packet from 172.217.17.65:80 to 108.162.129.80:51379 as SYN:ACK received but there is no active connection
[INFO] Sat Jan 28 02:39:15 2017 Blocked incoming TCP connection request from 178.220.112.121:27709 to 108.162.129.80:5358
[INFO] Sat Jan 28 02:39:13 2017 Blocked incoming TCP connection request from 94.183.131.58:3330 to 108.162.129.80:23
[INFO] Sat Jan 28 02:36:16 2017 Dropped packet from 192.168.0.101 to 206.248.154.170 (IP protocol 17) as unable to create new session
[INFO] Sat Jan 28 02:36:16 2017 Dropped packet from 192.168.0.101 to 23.34.211.66 (IP protocol 6) as unable to create new session
[INFO] Sat Jan 28 02:36:15 2017 Blocked incoming TCP connection request from 118.70.11.25:58962 to 108.162.129.80:2323
[INFO] Sat Jan 28 02:34:59 2017 Dropped packet from 192.168.0.101 to 104.208.165.109 (IP protocol 6) as unable to create new session
[INFO] Sat Jan 28 02:34:59 2017 Previous message repeated 1 time
[INFO] Sat Jan 28 02:34:57 2017 Dropped packet from 192.168.0.101 to 205.217.167.18 (IP protocol 6) as unable to create new session
[INFO] Sat Jan 28 02:34:57 2017 Blocked incoming TCP connection request from 95.0.123.67:52751 to 108.162.129.80:23
[INFO] Sat Jan 28 02:34:34 2017 Blocked incoming TCP packet from 172.217.17.65:80 to 108.162.129.80:54113 as SYN:ACK received but there is no active connection
[INFO] Sat Jan 28 02:34:11 2017 Blocked incoming ICMP error message (ICMP type 3) from 71.50.85.31 to 108.162.129.80 as there is no UDP session active between 108.162.129.80:22678 and 71.50.85.31:53
[INFO] Sat Jan 28 02:34:07 2017 Blocked incoming TCP connection request from 82.193.113.82:17292 to 108.162.129.80:23
[INFO] Sat Jan 28 02:33:18 2017 Dropped packet from 192.168.0.101 to 81.161.59.85 (IP protocol 6) as unable to create new session
[INFO] Sat Jan 28 02:33:16 2017 Blocked incoming TCP connection request from 183.60.48.25:12213 to 108.162.129.80:9527
[INFO] Sat Jan 28 02:32:48 2017 Blocked incoming TCP connection request from 211.209.68.74:20481 to 108.162.129.80:23
[INFO] Sat Jan 28 02:32:42 2017 Blocked incoming TCP connection request from 220.133.177.66:26107 to 108.162.129.80:23
[INFO] Sat Jan 28 02:31:48 2017 Dropped packet from 192.168.0.101 to 54.68.115.19 (IP protocol 6) as unable to create new session
[INFO] Sat Jan 28 02:31:47 2017 Previous message repeated 1 time
[INFO] Sat Jan 28 02:30:49 2017 Dropped packet from 192.168.0.101 to 23.34.218.22 (IP protocol 6) as unable to create new session
[INFO] Sat Jan 28 02:30:49 2017 Dropped packet from 192.168.0.101 to 172.217.0.161 (IP protocol 6) as unable to create new session
[INFO] Sat Jan 28 02:30:49 2017 Previous message repeated 2 times

Is the newest errors. I tried most of your ideas at the start of the page. I just cant test the router at a second location. Maybe we can start from the beginning and walk me through everything
Title: Re: EBR-2310 connection issues II
Post by: FurryNutz on January 29, 2017, 11:40:27 AM




Internet Service Provider and Modem Configurations
Title: Re: EBR-2310 connection issues II
Post by: seanml on January 29, 2017, 01:17:26 PM
Router: D-Link EBR-2310 Ethernet Broadband Router
Router version: B1
What region are you located? Ottawa, Ontario
[/u]
What ISP Modem service link speeds do you have: UP 1.08 mbps and Down 15.9mbps
By-pass the main host router and check internet connection by connecting a wired LAN PC directly to the ISP modem to verify connection access and ISP speeds.: Works perfect
Check cable between Modem and Router:Secured connection
If the ISP modem has a built in router, it's best to bridge the modem: Modem is a single port modem with no wifi/router capabilities (RCA/Thomson/Technicolor   TC4300) is modem
Title: Re: EBR-2310 connection issues II
Post by: seanml on January 31, 2017, 10:59:52 AM
where are the mtu settings for D-Link EBR-2310 Ethernet Broadband Router?
Title: Re: EBR-2310 connection issues II
Post by: FurryNutz on January 31, 2017, 11:17:27 AM
Maybe under Setup/Internet?


Title: Re: EBR-2310 connection issues II
Post by: seanml on February 04, 2017, 01:35:30 PM
naw not in there, would it be labelled MTU?
Title: Re: EBR-2310 connection issues II
Post by: FurryNutz on February 04, 2017, 01:47:55 PM
Most MTU features are kept under Internet manual settings sections in D-Link FW.

You don't see any MTU features anywhere in the UI?
Title: Re: EBR-2310 connection issues II
Post by: seanml on February 04, 2017, 01:55:00 PM
Cool found it, was alreayd at the proper setting. Should I use dynamic or static IP?
Title: Re: EBR-2310 connection issues II
Post by: FurryNutz on February 04, 2017, 03:31:35 PM
Where was it?

Dynamic for WAN IP? Depend on your ISP if your asking about this. Most use Dynamic unless you pay for a static IP address.
For LAN side devices, you can set static on those devices that don't need much internet access. Printer, NAS, cameras phones and controllers.
Title: Re: EBR-2310 connection issues II
Post by: seanml on February 04, 2017, 09:30:36 PM
alright, hmm not sure why the connection keeps bouncing on and off. Still cant find the issue in my control panel. I know it is stable when the router isn't connected
Title: Re: EBR-2310 connection issues II
Post by: FurryNutz on February 05, 2017, 12:50:30 PM
Swap LAN cable between modem and router?
Is DNS relay enabled or disabled, try both?
Title: Re: EBR-2310 connection issues II
Post by: seanml on February 06, 2017, 07:19:34 PM
found it, still me and the second pc keep going on and off with packet protocol 17 fails now
Title: Re: EBR-2310 connection issues II
Post by: FurryNutz on February 07, 2017, 06:09:49 AM
What Windows version are you using?
Is DNS relay enabled or disabled, try both?
What is the Mfr and model of the NIC adapter installed in this PC?
Did you set up an IP address reservation for the PC?
Do other devices exhibit that same issue as this one PC?
Title: Re: EBR-2310 connection issues II
Post by: seanml on February 07, 2017, 08:10:38 AM
What Windows version are you using?
Windows 7 ultimate

Is DNS relay enabled or disabled, try both?
enabled

What is the Mfr and model of the NIC adapter installed in this PC?
Qualcomm Atheros Killer e2200 Gigabit Ethernet Controller (NDIS 6.30)
Do I need to open computer to find model number?

Did you set up an IP address reservation for the PC?
Where do I do that?

Do other devices exhibit that same issue as this one PC?
Yes the laptop. When only the computer is hooked up to the router it works perfectly, but as soon as the laptop is hooked up they both have issues.
Title: Re: EBR-2310 connection issues II
Post by: FurryNutz on February 07, 2017, 08:24:47 AM
Does the LT (laptop) work by itself with out the PC connected?

What is the Mfr and model of the NIC on the LT?

Title: Re: EBR-2310 connection issues II
Post by: seanml on February 07, 2017, 02:29:32 PM
yes, also I read something online that this router has a hardware fault that causes this. I think I messed up
Title: Re: EBR-2310 connection issues II
Post by: FurryNutz on February 07, 2017, 04:44:03 PM
Well in all honesty, this model router was good up to 100Mb, however most NIC and wired devices now support 1000Mb speeds. Your only limiting your WAN and LAN connections by using 100Mb with this router. I'd get into something like a DGL-4500 or a DIR-655 Rev A B or C. Even a DIR-628 supports 1000Mb speeds if your wanting a cheap used router that could be found on amazon or flebay. There some good finds out there. Even if you found one of the routers I meantioned, you can upgrade the wifi by connecting up a newer AC class AP to the router and turn off the older wifi or slower wifi radio on those model router. I have been using my DGL-4500 lately for fun and have a DIR-890L connected to it running as a AP only. Great setup