D-Link Forums

D-Link VPN Router => DSR-500N => Topic started by: GlennXS on May 18, 2021, 08:27:25 PM

Title: 0dbM WiFi Transmit Power
Post by: GlennXS on May 18, 2021, 08:27:25 PM

I have a DSR-500N that reports no/0 transmit power; however i setup the transmit power value.  The reason i'm concerned is because various client devices in close proximity cannot see any AP broadcast as configured on this DSR-500N; however i setup its profiles/APs.  -Is it fair to say that the radio of this DSR-500N is broke?  That is, is there a test configuration that i could implement that should work regardless/every time?
 

Title: Re: 0dbM WiFi Transmit Power
Post by: FurryNutz on May 19, 2021, 05:43:24 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)

• What Hardware version is your router? Look at sticker under the router case.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
• What region are you located?

Even after a factory reset of the DSR?