D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-5222L => Topic started by: tpreadi on March 27, 2020, 12:40:07 AM
-
I Have a DCS-5222L which I have just bought (previously I had a DCL-5010L) So I am familiar with the setting on these cameras. When I Tick" Snapshot" then tick Trigger by "Motion" Then tick "Only during" and continue to tick the days of the week and a start time.
It starts correctly at the time and days specified but instead of (or how I think it should) activated on motion during only the set times and days it sends me continuous snapshots/video clips spaced out 1 minute apart. What am I doing wrong?
Two other concerns ; 1) on nighttime mode the picture flickers constantly - which could be the problem, as it might misconstrue it to be a motion - I can't seem to fix this I have the Frequency set to Auto.
2) I can't get this camera to have a green LED as it stays a solid red but it is connected to the WiFi and works well other than the emails.